Had a customer bring in his 98 Chevy S10 pickup.
Had the stock deck in there and was putting in a Jensen reciever.
Customer purchased a kit for the replacement but it was the wrong one and budget was tight, so, instead of just throwing it in there, I made him a custom ABS dash kit.
Fit like a glove and you can barely notice it's not a regular kit.
Had a customer that needed a deck installed, as well as the steering wheel controls integrated into the new unit.
Simple little install...did it on-site at the customer house.
Cheers
Had a customer come in with an 83 Mustang Foxbody.
Basic stock turn knob radio....my favorite!
This wasn't too bad...just had to get the radio out of the dash....worse shaft radio one yet.
It's like the manufacturer puts in the radio first...then builds the car. In order to get this bad boy out you have to dismantle the enture center console, then start undoing the dash.....79.5 screws and bolts later, you're able to strong arm that radio outta there.
The other issue with this car is that it's got a common ground speaker system...which is usually fun. This one was easy, sometimes they can be a realy pain.
Made a simple trim piece to match the existing trim piece and we're good to go now.
Cheers!
Got the newly painted pods attached, mounted and wired up.
Also, temporarily mounted the new RetroSounds radio in the dash...I say temporarily, because the previous owner used a badger or beaver of some type to make the hole a bit wider and the new radio doesn't sit in flush like i should.....so the owner will be repainting everything within the next year, so once that's done, the hole will be of perfect size and it'll look even more stock than it does already.
Everything turned out great, owner is stoked and it sounds great......already have another set that needs to be made!
Cheers
RSS Feed