......and I'm back from the dead!
When I woke up from my daze of being overworked, I found this yellow car thingy in my garage!
So I decided to take some pics of some things!!!!
Actually, I've just been stupid slammed and havent had time to post the 800+ Photos I have taking up most of my computers memory...so bare with me.
Aaaanyways, back on track:
Center console is where the client and I decided we'd put the Accuair controller and Race Logic control module. The Accuair is set back due to the fact that his iPhone6+ will run the air controls for the most part...plus, it's Accuair...so you really don't have to mess with it too much unless you have an 'Oh Shit' moment.
I cut the OEM cup holder insert to allow for at least 1 drink holder....then I fabricated a dual platform insert that was covered in suede to match the rest of the interior.
I fabricated a small plastic back piece and secured it chemically to the cut OEM drink holder and blended to match the seams.
Done and done!
When I woke up from my daze of being overworked, I found this yellow car thingy in my garage!
So I decided to take some pics of some things!!!!
Actually, I've just been stupid slammed and havent had time to post the 800+ Photos I have taking up most of my computers memory...so bare with me.
Aaaanyways, back on track:
Center console is where the client and I decided we'd put the Accuair controller and Race Logic control module. The Accuair is set back due to the fact that his iPhone6+ will run the air controls for the most part...plus, it's Accuair...so you really don't have to mess with it too much unless you have an 'Oh Shit' moment.
I cut the OEM cup holder insert to allow for at least 1 drink holder....then I fabricated a dual platform insert that was covered in suede to match the rest of the interior.
I fabricated a small plastic back piece and secured it chemically to the cut OEM drink holder and blended to match the seams.
Done and done!
RSS Feed