My buddy Chingy brought me his sub box he made to fit in the 'OEM' location where a sub would go in his 'slightly' new Axis wake board boat.
He made it to perfectly fit the Arc Audio Flatline 12, 12" woofer. It's a high output SQ subwoofer...so it only needs 1.0 Cu. Ft. of sealed goodness. I didn't get a before pic, but it was a standard birch box with a SHAT-TON of screws in it.....my job? Make it look puuurdy.
I 100% sealed the box inside with each and every corner/joint receiving about a 1/4" of resin 45's. Then the entire internal and external surfaces were resin'd to be waterproof and leak proof.
After that, a few good hours of body work were put into the face plate to make it smooth and ready to go. A 3" hole was cut out for a heater vent. Everything got 5 coats of DupliColor Bedliner with the subwoofer grill getting a nice gloss coat of White to match the boat a bit better.
I installed some gnarly 1/2" Steel bolts for speaker terminals so that it's easier to install and the box stays sealed.
The rest of the project will include the following Audio Components provided by Trax Customs:
Arc Audio KS1200.1 Mono Block Subwoofer Amplifier
Arc Audio KS300.4 4 Channel Amplifier (Tower Speakers)
Arc Audio KS300.4 4 Channel Amplifier (In-Boat Speakers)
Arc Audio Flatline 12 - 12" Subwoofer
Arc Audio KS605 6.5" Coaxial Speakers throughout (6-8 total)
WetSounds Revolution 10 Series Wake Board Tower Speakers (X2) 400 watts RMS each
WetSounds 3-Zone Equalizer for full control over this beast and Mic talk-back to riders
He made it to perfectly fit the Arc Audio Flatline 12, 12" woofer. It's a high output SQ subwoofer...so it only needs 1.0 Cu. Ft. of sealed goodness. I didn't get a before pic, but it was a standard birch box with a SHAT-TON of screws in it.....my job? Make it look puuurdy.
I 100% sealed the box inside with each and every corner/joint receiving about a 1/4" of resin 45's. Then the entire internal and external surfaces were resin'd to be waterproof and leak proof.
After that, a few good hours of body work were put into the face plate to make it smooth and ready to go. A 3" hole was cut out for a heater vent. Everything got 5 coats of DupliColor Bedliner with the subwoofer grill getting a nice gloss coat of White to match the boat a bit better.
I installed some gnarly 1/2" Steel bolts for speaker terminals so that it's easier to install and the box stays sealed.
The rest of the project will include the following Audio Components provided by Trax Customs:
Arc Audio KS1200.1 Mono Block Subwoofer Amplifier
Arc Audio KS300.4 4 Channel Amplifier (Tower Speakers)
Arc Audio KS300.4 4 Channel Amplifier (In-Boat Speakers)
Arc Audio Flatline 12 - 12" Subwoofer
Arc Audio KS605 6.5" Coaxial Speakers throughout (6-8 total)
WetSounds Revolution 10 Series Wake Board Tower Speakers (X2) 400 watts RMS each
WetSounds 3-Zone Equalizer for full control over this beast and Mic talk-back to riders
RSS Feed